![]() The side of the shelf attached to a wall stud does not need anchors. I placed the back plate up and inserted the screw into the anchor and drove it in until it felt secure. Then I just had to twist the anchor into the drywall until it was flush with the wall. I inserted the Phillips Head bit on my screwdriver into the hole of the anchor and pressed the point into the wall. The anchors would be used on the side not attached to a stud. The LACK shelf is actually a shell that is slid over this plate and two small screws attach the shelf to the back plate. ![]() I was now ready to attach the back plate to the wall. However, I waited to put the shelves up on a weekend when I would have a whole day to deal with anything else that might come up. After I don't know how many tries, on how many days, I had pencil dots marking some fairly consistent studs. However, no matter how many times I read the directions I kept coming up with different locations for the studs in my wall. I bought the highly recommended Black & Decker BullsEye laser and stud sensor. Target has some of the same tools for less money (Black & Decker, McCullouch, etc.).Small hardware stores beat the Big Box stores (Lowe's, Home Depot).Nylon self-drilling anchors for drywall also known as wallboard (see picture at top of post)īlack & Decker 6V PivotPlus rechargeable screwdriver/drillģ/8-inch drill bit (came with the PivotPlus) The trips were to buy these following items:īlack & Decker BullsEye level and stud finder I have receipts from 4 trips, but then there were the fruitless scouting missions here and here. ![]() of trips to a store in one month for this project: I found I had metal studs instead of wood ones, which changed what type of anchor I needed. (That is why this shelf is notorious for faulty installation and stability failure.) IKEA does not provide the hardware or even suggest what type you need for this item. I described to them what I was doing and they recommended the right screws and anchors for the project.ĭifficulties:Had to find the placement of studs in my wall The people who work there actually know what they're doing when it comes to DIY. It is a chain but much smaller than Home Depot or Lowe's. ![]() I went to my local small hardware store, Pleasant's hardware. Well, I was thoroughly justified in putting off installing this shelf for so long. Use a laser level for sure as well as make multiple measurements if required.After two years, I finally decided to tackle the IKEA LACK shelf. Overall, I can say that the product is OK and need to be used in conjunction with good deep screws that tightly fit. I have stressed the system a bit and found that leaving a gap between the screw, could be less that 2mm and it will spoil the experience. The worst part is the multiple rounds of fittings you need to do to get it right, else you will end up with a bit of a sag. The installation process is a pain and you should use a level, preferably a laser level to get it right. This product gets dirty quickly and can fade to a dull colour quickly. Needed to buy longer hex headed ones with their own plug set. It all depends on the screws as well as how deep you embed them into the wall. Then I was told it will handle 15 kilos and it does it under certain conditions. For example, I needed to buy a screw and plug set for this unit and multiple units of it. Difficult to get it straight and don’t tell you a few things Jacob My biggest gripe about IKEA is that you cannot get all the information from the website.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |